Recall record at a glance
| Official record | 25V002000 |
|---|---|
| Category | Vehicle Recalls |
| Recalling firm | Tesla, Inc. |
| Component | BACK OVER PREVENTION:SOFTWARE |
| Report date | Jan 7, 2025 |
| Location | United States |
What the recall covers
Tesla, Inc. (Tesla) is recalling certain 2024-2025 Model 3, Model S, 2023-2025 Model X, and Model Y vehicles. The computer circuit board may short, resulting in the loss of the rearview camera image. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 111, "Rear Visibility."
Potential consequence
A rearview camera that does not display an image reduces the driver's rear view, increasing the risk of a crash.
Remedy described by NHTSA
Tesla released an over-the-air (OTA) software update, free of charge. Tesla will also identify any vehicles that experienced a circuit board failure, or stress that may lead to a circuit board failure, and replace the affected computers, free of charge. Owner notification letters were mailed March 7, 2025. Owners may contact Tesla customer service at 1-877-798-3752. Tesla's number for this recall is SB-25-00-001.
Vehicle pages currently linked in our database
These are the make, model and model-year pages currently linked to this campaign in Recall Lookup USA. The official NHTSA record may cover additional vehicles.
Additional NHTSA notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153) or go to nhtsa.gov.
What to do next
Use the NHTSA recall lookup with your VIN for the most precise vehicle-specific result, then follow the remedy instructions provided by the manufacturer or an authorized dealer. A model-level campaign page cannot confirm whether a particular VIN is affected.
About this record
Recall Lookup USA preserves the most complete source information successfully retrieved. We do not create missing facts or infer affected lots or VINs. The official record may still change, so use the identifier above when verifying current instructions.