Recall record at a glance
| Official record | 20V766000 |
|---|---|
| Category | Vehicle Recalls |
| Recalling firm | Subaru of America, Inc. |
| Component | BACK OVER PREVENTION:DISPLAY FUNCTION |
| Report date | Dec 10, 2020 |
| Location | United States |
What the recall covers
Subaru of America, Inc. (Subaru) is recalling certain 2020 Legacy and Outback vehicles equipped with "high" grade and "mid" grade multimedia navigation. The August 2020 over-the-air software update may have timed out without completing the installation, corrupting the data, and causing the rearview display to shutoff intermittently. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."
Potential consequence
The intermittent loss of the rearview image reduces the driver's visibility and increases the risk of crash.
Remedy described by NHTSA
Subaru will notify owners, and dealers will reprogram the software and, if necessary, replace the Cockpit Control Module, free of charge. The recall began January 22, 2021. Owners may contact Subaru customer service at 1-844-373-6614. Subaru's number for this recall is WRH-20.
Vehicle pages currently linked in our database
These are the make, model and model-year pages currently linked to this campaign in Recall Lookup USA. The official NHTSA record may cover additional vehicles.
Additional NHTSA notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
What to do next
Use the NHTSA recall lookup with your VIN for the most precise vehicle-specific result, then follow the remedy instructions provided by the manufacturer or an authorized dealer. A model-level campaign page cannot confirm whether a particular VIN is affected.
About this record
Recall Lookup USA preserves the most complete source information successfully retrieved. We do not create missing facts or infer affected lots or VINs. The official record may still change, so use the identifier above when verifying current instructions.